How to improve the cooperation between smelting and continuous casting equipment of continuous casti

   Fuzhou Yishun Precision Industry Co., Ltd. will introduce some improvement plans for the coordination of smelting and continuous casting equipment of continuous casting and rolling mill, and we believe that the effect of continuous casting and rolling mill will be greatly improved.

   1. After the scrap is melted, it is transferred through the ladle, and the temperature of the molten steel is determined according to the lifting distance and the temperature in the workshop. Avoid too fast drop of steel water temperature, resulting in stacking and sticking phenomenon when pouring into the caster, resulting in slow flow of steel and seriously affecting production capacity.

   2. The external temperature is low, and the temperature drop of molten steel is fast. In order to solve this problem, the heat preservation ladle can be used to maintain the temperature of the molten steel, so as to ensure that the molten steel will not be viscous when entering the continuous casting machine.
   3. It is difficult for the continuous caster to continuously cast the billet, so the temperature can be raised by blowing oxygen outside. Therefore, the continuous caster must meet the requirements of "first continuous casting, then oxygen blowing". At the same time, cooling water is used to spray and cool the billet, which is cut and then enters the roughing mill.
   The above is the introduction of relevant content, I hope it can help you!